After the success (eventually) of the beer fridge I made with a dorm fridge and a cold plate, Nick decided he was ready to make the plunge into kegging and wanted one himself.
For this project, Nick had a bigger dorm fridge than I had previously used. The fridge that he used looked like a 4.6 cu. ft. fridge where mine was a 1.7 cu. ft. fridge. This will allow him to also store beer, yeast and any other items in it he wants to keep cold in addition to the cold plate.
The setup was very similar to what I had setup before the box and tap which is what I am currently using. The plan was simple; hole in the front of the fridge for 1/2in spur and tap, hose to cold plate, house out of cold plate, house out of fridge to keg, hose from keg to CO2. Pretty simple.
We started with the small hole from the keg into the fridge.
Sorry about the crappy photo. The hole was in the lower part of the fridge near where the motor is. This is a pretty convenient place to drill as long as you are careful. However, it doesn’t really matter where you drill with this size fridge because the colling element is the freezer, no freon in the walls like a large fridge.
From here we hooked up the CO2 and ran the line through to the cold plate.
He got the tubes, gages and CO2 tank from EJ Wren. Finally we drilled the hole through the front of the fridge using my handy dandy step drill bit. After we screwed in the tap and ran the hose, we were all done. Easy enough.
Nick said that the system has been working perfectly. He lucked out and was able to tweak the CO2 pressure so that there were no aggressive foam issues.
Again, sorry about the bad pics, next time I will get a real camera, not my camera phone.